11 . Optional: Issue the psshow command at the CLI prompt to display power supply status.
Fabric OS identifies the power supplies in a 8/80 S AN Switch fr om left to right as PS2 and PS1,
as shown in Figure 27 on page 61.
SANSwitchmanagementfeatures
SAN Switches use built-in managem ent tools to help you monitor fabric topology, check port status, and
debug the switc
h. Table 13 lists the management tools available.
When running IP over FC, these management tools must be supported by both HBA and
HBA drivers. For a list of supported HBAs, see the H P StorageWorks SAN design guide:
h
ttp://www. hp.com/go/sandesignguide.
Table 13 Management tools
Manag ement tool
Out-of-band s
upport In-band sup port
CLI—Up to two admin sessions and
four user sessions simultaneously
Ethernet or seri al connection
IP over FC
Web Tools—For information, refer to
the Web Tools administrator’s guide for
the Fabric OS version running on your
switch.
Ethernet or seri al connection
IP over FC
Standard SN
MP applications—For
informati
on, refer to the Fabric OS MIB
reference
manual for the Fabric OS
version ru
nning on your switch.
Ethernet or seri al connection
IP over FC
Fabric Manager (Optional)—For
information, refer to the Fabric
Manager User’s Guide.
Ethernet or seri al connection
IP over FC
Management Ser ver—For information,
refer to the Fabric OS administrator’s
guide and the Fabric OS command
reference manual for the Fabric OS
version running on your switch.
Ethernet or seri al connection
Native in-ba nd
interface (over HBA
only)
62
Operating the 8Gb SAN Switch
To Next Page
Loading...
