• For an HP System/e Rack, install two #10-32 x 1/2-inch Phillips pan-head screws with
captive star lock-washers and two #10 alignment washers in upper and lower hole
locations of the right rail. Then install t wo #10-32 x 1/2-inch Phillips pan-head screws
with captive star lock-washers and two #10 alignment washers in the upper and lower
hole locations of the left rail. See Figure 12.
Figure 12 A
ssembling the outer rails (HP System/e Rack)
5. Dependin
g on the device model, the SAN Switch Rack Mount Kit requires different screw types for
securing
the inner rails. Use Table 9 to determine the number and screw t ype for your specificswitch.
CAUTION:
Do not use
any scr ews other than those provided. Using longer screws than those provided
can cause damage to internal components.
Table 9 N umber of screws required to assemble the inner rails to the switch
Device model
#8-32 x 5 /16-inch
screws
#8-32 x 3/16-inch
screws
SAN Switch 2/16,
SAN Switch 2/8V , or
SAN Switch 2/16V
Ten (Fiv
eperrail)
SAN Switch 2/32 N/A
Twelve
nl
(Six per rail)
4/8 SAN Switch,
4/16 SAN Switch,
SAN Switch 4/32
Ten (Five per rail) N/A
4/32B SAN Switch
Six (Three per rail)
N/A
MP Rout
er
Six (Three per rail)
4/64 SAN Switch or
400 MP Router
Ten (Five per rail) N/A
8/8 SAN Switch,
8/24 SAN Switch,
8/40 SAN Switch,
8/80 SAN Switch
Ten (Five per rail)
34
Installing and configuring an 8Gb SAN Switch
To Next Page
Loading...
