HP StorageWorks MSA1000 User Manual

Installation Procedures - for all MSA1000 Deployments
46 MSA1000 Installation Guide
The power cord should be approved for use in your country. It must be rated for
the product and for the voltage and current marked on the product's electrical
ratings label. The voltage and current rating of the cord should be greater than the
voltage and current rating marked on the product. In addition, the diameter of the
wire must be a minimum of 1.00 mm² or 18 AWG. If you are using 18 AWG, your
maximum length may be up to 12 ft.
WARNING: To reduce the risk of electric shock or damage to the equipment:
■ Do not disable the power cord grounding plug. The grounding plug is an
important safety feature.
■ Plug the power cord into a grounded (earthed) electrical outlet that is easily
accessible at all times.
■ Unplug the power cord from the power supply to disconnect power to the
equipment.
■ Route the power cord so that it is not likely to be walked on or pinched by
items placed against it. Pay particular attention to the plug, electrical outlet,
and the point where the cord is attached to the MSA1000.
Figure 17: Connecting the power cords

HP StorageWorks MSA1000 Specifications

General

RAID levels	0, 1, 0+1, 5
Certification	Microsoft Cluster Server Certification\\r Hewlett Packard Data Protector\\r VERITAS Backup Exec and NetBackup\\r Legato NetWorker for Windows\\r Computer Associates BrightStor Enterprise Backup
Internal memory	256 MB
Memory clock speed	- MHz
Internal memory type	-
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	10 - 90 %
Supported storage drive interfaces	SCSI
Windows operating systems supported	Yes
Harmonized System (HS) code	84733080

Weight and Dimensions

Depth	52.1 mm
Width	48.3 mm
Height	17.5 mm
Weight	31210 g