HP StorageWorks MSA1000 User Manual

Configuration Procedures - for OpenVMS Environments
79MSA1000 Installation Guide
9. After reinstalling the left controller, the following message is displayed:
CLONE FIRMWARE? ‘<‘ =NO, ‘>’=YES
Press the > button on the left controller display to begin the cloning process.
Note: If you take no action, the firmware clone starts automatically.
The message ROM CLONING STARTED is displayed, indicating that the firmware
on the left controller is being cloned. Cloning takes approximately one
minute.
After the firmware clone is complete, the left controller displays the message
ROM CLONING DONE, followed by ARRAY CONTROLLER RESTARTING.
The controller will restart within 30 seconds. The left controller displays
COMPAQ MSA1000 STARTUP COMPLETE when the startup routine is complete.
10. Use the
show this_controller or show other_controller commands to
verify the firmware download.
The MSA1000 firmware has now been upgraded with firmware that supports
Tru64 UNIX® and TruCluster Server.

HP StorageWorks MSA1000 Specifications

General

RAID levels	0, 1, 0+1, 5
Certification	Microsoft Cluster Server Certification\\r Hewlett Packard Data Protector\\r VERITAS Backup Exec and NetBackup\\r Legato NetWorker for Windows\\r Computer Associates BrightStor Enterprise Backup
Internal memory	256 MB
Memory clock speed	- MHz
Internal memory type	-
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	10 - 90 %
Supported storage drive interfaces	SCSI
Windows operating systems supported	Yes
Harmonized System (HS) code	84733080

Weight and Dimensions

Depth	52.1 mm
Width	48.3 mm
Height	17.5 mm
Weight	31210 g