logical library. The Library allows a cartridge that was placed in the mailslot by the operator to be
moved into any logical library. If sharing the mailslot among logical libraries is an issue in your
environment or is not supported by your backup application, disable the mailslot.
Each logical library has a unique serial number and World Wide Identifier (WWID), which can be
found in the RMI Identity: Library screen. For more information on WWIDs, see “World Wide
identifiers” on page 41.
NOTE:
Libraries that require a license to enable all slots must have all slots licensed to operate with the Library
Extender.
Partitioning the MSL2024 and MSL8048 Tape Libraries
An MSL2024 Tape Library with two tape drives can be configured into two logical libraries. Each
logical library is assigned one tape drive and one magazine.
An MSL8048 with at least two tape drives can be configured into two logical libraries. Each logical
library is assigned at least one tape drive and two magazines.
Table 13 MSL2024 and MSL8048 Tape Libraries partitioned into two logical libraries
MagazinesTape drives
MSL2024
MSL8048
1. Logical library 1 tape drives and magazines
2. Logical library 2 tape drives and magazines
Partitioning the MSL4048 and MSL8096 Tape Libraries
The MSL4048 and MSL8096 Tape Library can be configured into two to four logical libraries,
depending on the number of tape drives installed. The MSL4048 supports up to two full-height tape
drives or up to four half-height tape drives. The MSL8096 supports up to four half-height or full-height
tape drives. For the tape drives and magazines assigned to each logical library see Table
14 on page 30, Table 15 on page 31, and Table 16 on page 31.
HP StorageWorks MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and service
guide 29
To Next Page
Loading...
Need help?
General
