HP StorageWorks MSL2024 User Manual

Figure 61 Configuration: Network page
.
You may change the:
• Protocol version — selects the Internet Protocols that will be enabled. Select IPv4 only, IPv6 only,
or both IPv4 and IPv6 protocols. The default is the IPv4 protocol only.
• Host Name — enter the host name provided by your network administrator for the Library.
• Domain name — enter the domain name provided by your network administrator for the Library.
• Enable HTTPS — when On, the RMI can only be accessed through an HTTPS connection.
• Restricted Network Access — when On, disables all non-essential network functionality that is not
required for normal product operation. In most circumstances leave this On.
For IPv4, you may change the:
HP StorageWorks MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and service
guide 89

HP StorageWorks MSL2024 Specifications

General

Number of Slots	24
Number of Drives	1 or 2
Tape Technology	LTO Ultrium
Drive Bays	1 or 2
Interface	SCSI, SAS
Drive Type	LTO-3, LTO-4
Supported Drives	LTO-3, LTO-4
Operating System Support	Windows, Linux, HP-UX, Solaris, AIX
Dimensions	8.9 x 48.0 x 44.8 cm