NOTE:
SAS signal rates require clean connections between the HBA and tape drive. Do not use adapters or
converters between the HBA and the tape drive. For reliable operation, use a maximum SAS cable
length of six meters.
Powering on the device
WARNING!
This product can
only
be used with an HP-approved power cord for your specific geographic region.
Use of a non-HP-approved power cord may result in: 1) not meeting individual country specific safety
requirements; 2) insufficient conductor ampacity that could result in overheating with potential personal
injury and/or property damage; and 3) an unapproved power cord could fracture resulting in the
internal contacts being exposed, which potentially could subject the user to a shock hazard. HP
disclaims all liability in the event a non-HP-approved power cord is used.
To power on the Library:
1. To use the web-based management interface, connect an Ethernet cable to a working LAN
connection and to the Ethernet connector on the back of the Library.
2. Attach the power cable to the power connector on the back panel of the Library (see Figure 31).
Figure 31 Attaching the power cord
.
3. Plug the power cable into the nearest properly grounded power outlet.
4. Power on the device by pressing the power button located on the front panel. Check the LCD
screen to make sure it has power. If not, check the power connections and your power source.
During the Power On Self Test (POST), all four LEDs are illuminated briefly, followed by a flashing
Ready LED. When the initialization sequence is complete, the Home screen is displayed. If the
inventory takes over five minutes, the splash screen is displayed. Press any button to see the Home
screen.
5. Plug in the host server and all attached devices.
6. Power on any other devices you powered off earlier.
7. Power on the server.
Configuring the device
Now that the Library is connected to the host and powered on, configure it for your environment.
HP StorageWorks MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and service
guide 55
To Next Page
Loading...
Need help?
General
