• Static Addressing — when Enabled, the device will use a statically-configured address.
• Static Assigned Address — the IPv6 address when Static Addressing Enabled is On.
Status
Viewing dynamic device information
The Status: Library page displays dynamic information about the device. When you click Refresh, the
status is updated immediately.
Figure 50 Status: Library page
.
You can see, but not modify, the following:
• Status — the overall status of the device
The device is fully operational and no user interaction is required.
User attention is necessary, but the device can still perform most operations.
User intervention is required and the device is not capable of performing some operations.
• Cartridge in Transport — the slot number where the tape currently in the robot originated. None
if there is not a tape in the robotic.
• Odometer — the total number of moves the device has performed since its manufacture.
• Total Power On Time — the number of days, hours, and minutes that the device has been powered
on since its manufacture.
• Robotic Status — the current status of the robotics and a description of the operation the robot is
currently performing.
• Internal Temperature — the internal temperature reported by the device.
• Power Supply Status — the current status of each of the installed power supplies. (MSL4048,
MSL8048, and MSL8096)
HP StorageWorks MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and service
guide 77
To Next Page
Loading...
Need help?
General
