HP StorageWorks MSL8096 - Using the MSL4048, MSL8048, and MSL8096 Operator Control Panel; Using the Remote Management Interface; RMI Login Page

Using the MSL4048, MSL8048, and MSL8096 operator control panel
Removing magazines requires the administrator password.
To remove magazines:
1. From the Operations menu, select Unlock Left Magazines or Unlock Right Magazines.
NOTE:
The MSL8048 will only unlock the left magazines.
2. Enter the administrator password if requested.
3. Pull all the magazines you want to remove out a few centimeters or inches to move them past the
latch.
4. Pull the magazines out one at a time.
5. The Library cannot perform any other oper ation until the magazines are replaced . After exchanging
tapes in a magazine, slide the magazine completely into the Library. Each magazine locks into
place after it is correctly installed. When all magazines are in place, the Library inventories the
replaced magazines.
Using the remote management interface
To login, select the Administrator Account Type, enter the administrator password, and press Sign In.
Figure 111 RMI login page
.
Go to the Operations: Magazines page. This page allows you to release the right, left, or both
magazines from the Library.
HP StorageWorks MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and service
guide 225