Figure 49 Identity: Network page
.
You can see, but not modify:
• MAC Address — a unique identifier for the library controller network interface
• Full Qualified Domain Name — the fully qualified domain name for the device
• Clock Synchronization Configuration (SNTP) — When Enabled, the device will obtain the current
time and date from the configured SNTP server.
When IPv4 Addressing is Enabled, you can see, but not modify:
• IPv4 DNS Server 1 and IPv4 DNS Server 2 — addresses of the configured DNS servers used when
DHCP Addressing is not Enabled.
• DHCPv4 Addressing — When Enabled, the device will request an IP address from a DHCP server
each time the device is booted.
• IPv4 Address — the Library network address
• Subnet Mask — The network mask of the library controller used when DHCP Addressing is not
Enabled.
• Default Gateway — the gateway used when DHCP Addressing is not Enabled.
When IPv6 Addressing is Enabled, you can see, but not modify:
• Stateless Addressing — when Enabled, the device will generate an address for itself based on
the routing information obtained from a router advertisement and the MAC address. The device
can manage up to five global addresses at the same time, which can be assigned from different
routers.
• DHCPv6 Addressing — when Enabled, the Library will request an IP address from a DHCP server
each time the device is booted.
Operating the Tape Library76
To Next Page
Loading...
