IMPORTANT:
Once you reset the administrator password to null, you will not be able to access the administrator
functions in the RMI until you set an administrator password through the OCP. To
change
the
administrator password, use “Configuration: Password page” on page 93.
The saved configuration database will make it easier to recover the device configuration if you need
to replace the chassis or library controller. This feature is also useful when installing multiple devices.
Either save the configuration before configuring the network or ensure that only one device with the
same network configuration is on the network at a time until they have unique network identities.
NOTE:
You can save the device configuration to a USB flash drive from the OCP. For the MSL2024, see
“Saving and restoring the Library configuration (Configuration > Save/Restore
Configuration)” on page 120. For the MSL4048, MSL8048, and MSL8096, see “Saving and restoring
the Library configuration (Configuration > Save/Restore)” on page .
Figure 67 Configuration: Save/Restore page
.
The restored factory default settings are:
• SCSI addresses:
• MSL2024: A full-height tape drive has SCSI ID 4. The bottom half-height tape drive has SCSI
ID 4 and the top drive has SCSI ID 5.
• MSL4048: All full-height tape drives have SCSI ID 4. Half-height drive slots have SCSI ID of
4, 5, 4, 5 from the bottom up.
• MSL8048 and MSL8096: All tape drives have SCSI ID 4.
• Fibre Channel drive configuration: Automatic speed, auto port type
• Master drive: reset to Drive 1 or the lowest numbered existing drive
• Drive power: all drives powered on
• Active slots: maximum possible
• Library mode: Automatic
• Loop: No
Operating the Tape Library96
To Next Page
Loading...
Need help?
General