Removing and replacing the 2 SFF stacked riser cage backplaneRemoving and replacing the 2 SFF stacked riser cage backplane
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove all drives.
Note where each drive was installed.
6. Disconnect all cables from the drive backplane.
7. Remove the drive cage.
8. Remove the drive backplane.
To Next Page
Loading...
