ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the Systems Insight DisplayRemoving and replacing the Systems Insight Display
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Disconnect the cable from the system board .
Carefully feed the cable to the front of the server.
6. Remove the display.
To Next Page
Loading...
