4. Remove the access panel .
5. Remove the fan cage.
6. Remove all drives.
Note where each drive was installed.
7. Remove the 8 SFF drive cage .
8. Remove the drive backplane.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the 2 SFF front drive cageRemoving and replacing the 2 SFF front drive cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
To Next Page
Loading...
