Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove all hot-plug hard drives .
6. Do one of the following:.
Remove the fan cage.
Remove the midplane drive cage .
7. Disconnect all cables from the universal media bay.
8. Remove the universal media bay.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the SFF universal media bayRemoving and replacing the SFF universal media bay
To Next Page
Loading...
