Server warnings and cautions
T-25 Torx screwdriver
About this taskAbout this task
To remove the server from a Hewlett Packard Enterprise, Compaq-branded, Telco, or third-party rack:
ProcedureProcedure
1. Power down the server.
2. Disconnect the rear cabling.
3. Extend the server from the rack .
4. Release the rail latches and remove the server from the rack.
5. Place the server on a sturdy, level surface.
Remove the access panelRemove the access panel
About this taskAbout this task
WARNING:WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power supplies, and internal system
components to cool before touching them.
CAUTION:CAUTION:
Do not operate the chassis for long periods with the access panel open or removed. Operating the chassis in this manner
results in improper airflow and improper cooling that can lead to thermal damage.
ProcedureProcedure
1. Power down the server.
2. If installed, release the cable management arm .
To Next Page
Loading...
