6. Remove all drives.
Note where each drive was installed.
7. Remove the drive cage.
8. Remove the drive backplane.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the 8 SFF drive backplaneRemoving and replacing the 8 SFF drive backplane
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
To Next Page
Loading...
