ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the chassis intrusion detection switch.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a DIMMRemoving and replacing a DIMM
About this taskAbout this task
To identify the DIMMs installed in the server, see DIMM slot locations.
ProcedureProcedure
1. Power down the server.
To Next Page
Loading...
