ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a hot-plug E3.S driveRemoving and replacing a hot-plug E3.S drive
About this taskAbout this task
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Back up all server data.
2. If installed, remove the front bezel .
3. Observe the drive LED status and determine if the drive can be removed.
4. Remove the drive.
To Next Page
Loading...
