5. Remove the power supply.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the Removing and replacing the HPEHPE 800 W Flex Slot -48 VDC hot-plug power supply 800 W Flex Slot -48 VDC hot-plug power supply
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items:
No. 1 Phillips screwdriver
If you are replacing the factory installed ground lug, use the KST RNB5-5 crimp terminal ring or equivalent. Use an M5-0.80 x 8 screw to
attach the ground lug to the power supply.
About this taskAbout this task
To Next Page
Loading...
