Note where each drive was installed.
6. Remove the fan cage.
7. Disconnect all cables from the drive backplane.
8. Remove the drive cage.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing an EDSFF drive backplaneRemoving and replacing an EDSFF drive backplane
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the fan cage.
To Next Page
Loading...
