ItemItem DescriptionDescription
1 Processor-heatsink
module
2 Heatsink nuts
3 Heatsink latches
4 Processor carrier latches
5 Alignment screws
6 Bolster plate
This module consists of the heatsink attached to the processor that is already secured in its carrier.
HPEHPE Basic Drive LED definitions Basic Drive LED definitions
The HPE Basic drive carrier has the following LEDs:
Amber/blue LED—Managed by the drive backplane in conjunction with the storage controller and is used to indicate drive status.
Green LED—Managed by the drive itself and indicates the drive activity.
ItemItem LEDLED StateState DefinitionDefinition
1 Fault/Locate Solid amber This drive has failed, is unsupported, or is invalid.
Solid blue The drive is operating normally and being identified by a
management application.
Flashing amber/blue (1
flash per second)
The drive has failed, or a predictive failure alert has been received
for this drive. The drive has also been identified by a management
application.
Flashing amber (1 flash per
second)
A predictive failure alert has been received for this drive. Replace
the drive as soon as possible.
Off The drive is operating normally and not being identified by a
management application.
2 Online/Activity Solid green The drive is online and has no activity.
Flashing green (1 flash per
second)
The drive is doing one of the following:
Rebuilding or performing a RAID
Performing a stripe size migration
Performing a capacity expansion
Performing a logical drive extension
Erasing
Spare part activation
Flashing green (4 flashes
per second)
The drive is operating normally and has activity.
Off The drive is not configured by a RAID controller or is a spare drive.
1
1
To Next Page
Loading...
