FusionModule800 Smart Small Data Center
Installation Guide (Six Fans)
Copyright © Huawei Technologies Co., Ltd.
3. Reinstall the water detector cover by referring to Step 1.
Step 2 Figure 3-198 shows how to connect the water detection cable to the conversion cable.
Figure 3-198 Connecting cables
(1) Conversion cable end B, connected to
the water detection cable
(2) Water detection cable end A, connected
to the conversion cable
The water detection cable and conversion cable are interconnected through the male and female
connectors.
Step 3 Connect the other end of the conversion cable to the water detector, as shown in Figure 3-199.
Figure 3-199 Connecting the water detector
Step 4 Plan the installation position for the fastener of the water detection cable. Ensure that the
water detection cable placed on the fastener is in good contact with the floor.
Step 5 Tear off the protection paper from the rear of the fastener, and then securely attach the
fastener to the floor.
If the fastener cannot be securely attached to the floor, perform Step 6.
If the fastener can be securely attached to the floor, perform Step 7.
Step 6 Drill holes in the floor with the same dimensions as the expansion bolts for the fastener. Use
the expansion bolts to secure the fastener to the floor, as shown in Figure 3-200.
To Next Page
Loading...
Need help?
General