16
1.57 Why does my phone automatically connect to another
Wi-Fi network?
When the quality of the Wi-Fi connection is poor, your phone will automatically connect to
another known Wi-Fi network with a stronger signal (if available).
1.58 Why does my phone automatically connect to a Wi-Fi
network when I am using a mobile data connection?
1. The signal strength of the Wi-Fi network that you were previously connected to has
improved or you have a poor mobile data connection.
2. You disabled mobile data services.
1.59 How can I set up a connection between my phone and
a Huawei wrist band?
1. For the paired connection for the first time:
After the wrist is powered on, the Bluetooth icon in the left upper corner of the screen
blinks, indicating that the phone is available for paired connection.
Enable the Bluetooth function on the phone and select HUAWEI BX-XXX in the
Bluetooth list.
2. For the paired connection for the second time:
− After the pairing between the phone and the wrist band is released, you can perform
the following steps to re-pair them: press and hold the side button on the wrist band
for 3s; touch the Bluetooth icon on the screen; when the icon starts blinking,
enable the Bluetooth on the phone and select HUAWEI BX-XXX in the Bluetooth
list.
− The wrist band can simultaneously connect to two phones. To connect the wrist band
to the second phone, perform the following steps: press and hold the side button on
the wrist band for 3s; touch the Bluetooth icon on the screen; when the icon
starts blinking, enable the Bluetooth on the phone and select HUAWEI BX-XXX in
the Bluetooth list of the second phone. (Note: At this time, the wrist band is
disconnected from the first phone. You can select HUAWEI BX-XXX in the
Bluetooth list of the first phone. When digit "2" is displayed in the lower right corner
of the Bluetooth icon on the wrist band, the wrist band is successfully connected to
two phones.)
− After the phone is connected to the Bluetooth device, open the Huawei Wear app and
enter the main interface under the guidance. Slide down on the main screen to
synchronize the data for the first time. After the synchronization is successful, the
wrist band time and information have been initialized. Then, you can use the wrist
band normally.
To Next Page
Loading...
