Figure 8-42 Configuring Intrusion Area
You can click Clear to clear the areas you drawn.
The defense region parameters can be set separately.
Step 3 Choose the region to be configured.
l Threshold: Range [0-10s], the threshold for the time of the object loitering in the region. If
you set the value as 0, alarm is triggered immediately after the object entering the region.
l Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the object which
can trigger the alarm, when the sensitivity is high, a very small object can trigger the alarm.
l Percentage: Range [1-100]. Percentage defines the ratio of the in-region part of the object
which can trigger the alarm. For example, when you set the percentage as 50%, half of the
object entering the region will trigger the alarm.
----End
Arming Schedule is configured to set the time you want the function to be enabled.
Step 1 Click Edit to set the arming schedule.
Step 2 Choose to trigger alarm actions as Notify Surveillance Center, Send Email, Upload to FTP and
Trigger Channel or trigger the Alarm Output.
Step 3 Click
to save the settings.
----End
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide
8 Network Camera Configuration
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
105
To Next Page
Loading...
