Huawei IPC6131-WD-A - Configure NAT Settings

Figure 8-17 Email Configuration Interface
Step 3 Configure the following settings:
l Sender: The name of the email sender.
l Sender's Address: The email address of the sender.
l SMTP Server: The SMTP Server IP address or host name (e.g., smtp.263xmail.com).
l SMTP Port: The SMTP port. The default TCP/IP port for SMTP is 25 (not secured). And the
SSL SMTP port is 465.
l Enable SSL: Check the checkbox to enable SSL if it is required by the SMTP server.
l Attached Image: Check the checkbox of Attached Image if you want to send emails with
attached alarm images.
l Interval: The interval refers to the time between two actions of sending attached pictures.
l Authentication (optional): If your email server requires authentication, check this checkbox
to use authentication to log in to this server and enter the login user Name and password.
l Choose Receiver: Select the receiver to which the email is sent. Up to 2 receivers can be
configured.
l Receiver: The name of the user to be notified.
l Receiver's Address: The email address of user to be notified.
Step 4 Click to save the settings.
----End
8.3.11 Configure NAT Settings
Step 1 Enter the NAT settings interface: Configuration >Advanced Configuration >Network > NAT
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide
8 Network Camera Configuration
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
83