NOTE
Refer to B Port Mapping for port mapping details.
Step 5 Visit the IPC through a web browser over the Internet.
Figure 5-4 Connecting through a router (Internet)
----End
5.2.2 Dynamic IP Connection
Before you start, obtain a dynamic IP address from your ISP. With the dynamic IP address, you
can connect an IPC to the Internet through a modem or a router.
Connecting an IPC through a Router
Step 1 Connect the IPC to the router.
Step 2 In the camera, set the LAN IP address, subnet mask, and gateway.
Step 3 In the router, set the PPPoE user name and password.
Step 4 Set port mapping, such as 80, 8000, 8200, and 554 ports. Seek help from the router manufacturer
for port mapping.
NOTE
Refer to B Port Mapping for port mapping details.
Step 5 Obtain a domain name from a domain name provider.
Step 6 Set DDNS parameters on the setting page of the router.
Step 7 Visit the camera with the obtained domain name.
----End
Connecting an IPC through a Modem
Network camera supports PPPoE auto dial-up. An IPC automatically obtains a public IP address
by ADSL dial-up after connecting to a modem.
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide
5 Network Connection and Setup
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
58
To Next Page
