Power, Video and GND pins are used when the auto-iris is driven by video; Damp+, Damp-,
Drive+ and Drive- pins are used when the auto-iris is driven by DC.
3.4.2 Lens Installation
Step 1 Dismount the cover of the camera sensor.
Step 2 Install the lens on the sensor and rotate it clockwise until it is tighten.
Step 3 Connect the cable of the lens to the auto-iris interface on the side-panel of the camera. (Skip this
step if you use manual iris.)
Step 4 Adjust the focus until you get the satisfied image and the lock the focus adjusting lever.
NOTE
If the lens to be installed is C-type lens, a CS adaptor must be used.
----End
3.4.3 SD Card Installation
There is a SD card slot on the back panel of the camera.
Step 1 Insert the SD card into the card slot.
Step 2 Press the SD card slightly to install it.
Step 3 To take out the SD card, press the card again and it will be ejected.
----End
3.4.4 Pendant Installation
Step 1 Install the ceiling mount to the ceiling with the supplied expansion screws.
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide
3 Camera Installation
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
22
To Next Page
Loading...
