Step 3 Click to save the settings.
----End
8.6.6 Configuring Face Detection
NOTE
Face detection is only for certain modules, check the specification for whether the module supports the
function.
Step 1 If you enable the face detection, once a face appears in the surveillance area, it will be detected
and certain actions may be triggered by the detection.
Figure 8-40 Face Detection Interface
Step 2 Enter the face detection Settings interface: Configuration > Advanced Configuration > Events
> Face Detection.
Step 3 Check the Enable Face Detection to checkbox to enable the function.
Step 4 (Optional)You can check the Enable Dynamic Analysis for Face Detection checkbox if you want
the face detected get marked with rectangle in the live view.
NOTE
Select disable the rules from Configuration-Local Configuration-Live View Parameters-Rules if you don't
want the detected face marked with the green frame.
Step 5 Configure the sensitivity [1~5] of the face detection.
Step 6 (Optional)You can also configure the linkage action for face detection.
NOTE
The face detection is only supported by a certain series of camera modes. And it doesn't support any linkage
method.
----End
8.6.7 Configuring Audio Exception Detection
Audio exception detection detects the abnormal sounds, such as the silence detection,
environment noise detection, and current noise detection.
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide
8 Network Camera Configuration
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
103
To Next Page
Loading...
