Step 5 You can also choose the PTZ linking for the alarm input if your camera is installed with a pan/
tilt unit. Check the relative checkbox and select the No. to enable Preset Calling, Patrol Calling
or Pattern Calling.
Step 6 You can copy your settings to other alarm inputs.
Step 7 Click
to save the settings.
----End
8.6.4 Configuring Alarm Output
Step 1 Enter the Alarm Output Settings interface: Configuration>Advanced Configuration> Events
> Alarm Output.
Step 2 Select one alarm output channel in the Alarm Output drop-down list. You can also set a name
for the alarm output (optional).
Step 3 Set the Delay time to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min. The delay time refers to the
time duration that the alarm output remains in effect after alarm occurs.
Step 4 Click
to enter the Edit Schedule Time interface. The time schedule
configuration is the same as the settings of the arming schedule for motion detection Refer to
Task 2: Set the Arming Schedule for Motion Detection in 8.6.1 Configuring Motion
Detection .
Step 5 You can copy the settings to other alarm outputs.
Step 6 Click
to save the settings.
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide 8 Network Camera Configuration
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
101
To Next Page
Loading...
