Figure 8-2 Time Settings
Step 2 Select the Time Zone.
Select the Time Zone which is the closest to the location of the camera from the drop-down
menu.
Step 3 Select the Time Sync.
l Synchronizing Time by NTP Server
Check the checkbox to enable the NTP function.Configure the following settings.
Figure 8-3 Time Sync by NTP Server
– Server Address: IP address of NTP server.
– NTP Port: Port of NTP server.
– Interval: The time interval between the two synchronizing actions with NTP server.
NOTE
If the camera is connected to a public network, you should use a NTP server that has a time
synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44). If the camera is set in a customized network, NTP software can be used to establish
a NTP server for time synchronization.
l Synchronizing Time Synchronization Manually
Enable the Manual Time Sync function and then click to set the system time from the
pop-up calendar.
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide
8 Network Camera Configuration
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
73
To Next Page
Loading...
