Parameter
Index
Meaning Default Setting
49 Flag of whether using user-defined ring 15 as default
ring or not and flag of whether enable the optimization
of CC0SASL board name or not.
In the case of the binary system: From the lowest bit to
the highest bit, if the sixth bit is 0, it indicates that user-
specified ringing 15 is the default ringing; if the sixth
bit is 1, it indicates that user-specified ringing 15 is not
used. If the seventh bit is 0, it indicates that the
CC0SASL board name optimization function is
enabled; if the seventh bit is 1, it indicates that the
CC0SASL board name optimization function is
disabled.
If the two functions are both enabled, the value of this
parameter is 1111111100111111 in binary format and
is 65343 in decimal format.
65535
50-51 Reserved parameters 65535
52 Flag of whether to allow deleting a user forcibly. 0: not
allow; 1: allow
0: not allow
53 Configuration for the DTMF signal detection. 0: Q.24;
1: Russia
0: Q.24
54-56 Reserved parameters 65535
57 Flag of enabling or disabling the board line exception
report function. 0: enable; 1: disable
1: disable
58-65 Reserved parameters 65535
66 Flag of whether to modify the TEI value when the
softswitch is interconnected. 0: universal standard and
not modify; 1: set TEI to 1
0: universal
standard and not
modify
67-75 Reserved parameters 65535
76
Preamble letter used for selecting the calling number of
the DTMF to be issued. 12: A; 13: B; 14: C; 15: D.
15: D
77 Reserved parameters 65535
78
Flag of support R2 over analog line. 0: not support; 1:
support
0: not support
79-80 Reserved parameters 65535
81 Flag of the subscriber board supporting the low power
consumption. 0: not support; 1: support
1
82 Flag of reporting the out-of-service (OOS) of the user
port when the LOS fault occurs on the U port. 0: not
report; 1: report.
0: not report
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI A Additional Information
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
124