English - 28
2.7 Tools menu, functions
Via the Tools menu you can access data about the
mower’s function, test functions and special settings.
• Info
Information about current status of software,
sensors, battery, loop signal etc.
• History, total
Key data, which gives an overview of
a mower’s age and function.
• History, trip
Resettable key data.
• Test
Actively test the mower’s different
components and functions.
• Special settings
Turn off loop detection, demo mode,
installation settings lock.
• Calibrate
Calibrate the tilt sensor and guide wire.
2.7.1 Info
The values displayed in this sub-menu show the
current status of the mower’s different subsystems,
e.g. software, battery, motors and sensors. The menu
can be used in connection with e.g. troubleshooting.
The General, Battery, Loop and Sensors functions
show the same information as in the Quick Info menu
above.
The Info - Motors - Wheel menu shows for the right
and left wheel motors:
• Speed: The wheel motors’ speed in cm/s.
• Current: Nominal power consumption,
measured in mA.
• Power: The actual power the wheel motors
are currently being operated with. This varies
depending on for instance the inclination the
mower is operating on.
The Info - Motors - Cutting menu shows:
• Speed: The blade motor speed, nominal
speed is 2 300 rpm.
• Current: Nominal power consumption,
measured in mA.
Info
History, total
History, trip
Test
Special settings
Calibrate
General
Battery
Loop
Sensors
Motors
2. SPECIAL MENU FUNCTIONS
TH_1158203_310_315_GARDENA_US.indd 28 2016-05-11 10:16:06
To Next Page
Loading...
Need help?
General
