English - 41
• The rst time a new robotic lawnmower leaves
the charging station, for instance in the start-up
sequence.
• In the Settings - Guide calibration function.
• The rst time after Reset all user settings.
• The rst time after programming the main circuit
boards.
3.6 One robotic lawnmower for
several working areas
(Only for Husqvarna Automower® 315)
The unique coupling between mower and charging station
is saved in the proles. This allows up to three different
charging stations to be coupled to the same robotic
lawnmower.
• Coupling a new charging station to the robotic
lawnmower:
• First save a prole to be used with the original charging
station.
• Then place the mower in the new charging station
being coupled to the mower.
• Select Security-New loop signal.
• Save a prole for the new charging station.
In order to use the robotic lawnmower in the original
charging station, the rst prole must now be selected. In
order to use the robotic lawnmower in the new charging
station, the new prole must now be selected.
3.7 Even mowing results in complex
working areas
The robotic lawnmower is equipped with setting options to
ensure consistent mowing results even in complex working
areas Settings are carried out in Lawn coverage. If these
settings are not changed, the area near the charging station
will be cut more than areas further away from it or beyond
narrow passages.
3. INSTALLATION
TH_1158203_310_315_GARDENA_US.indd 41 2016-05-11 10:16:11
To Next Page
Loading...
Need help?
General
