English - 3
1 Function 5
1.1 Husqvarna Automower® 310/315, what is what? 5
1.2 GARDENA R100Li, R100LiC,R130Li, R130LiC and R160Li,
what is what? 6
1.3 Introduction 7
1.4 Technical Data 8
1.5 Software 10
1.6 Mowing technique 11
1.7 The loop system’s control signals 13
1.8 The loop system’s status 14
1.9 Boundary loop 14
1.10 Guide loop 16
1.11 Searching methods to nd the charging station 16
1.12 Automatic detection of passages 18
1.13 Docking and charging 18
1.14 Battery 18
1.15 Sensors 19
2 Special menu functions 20
2.1 Quick Info 20
2.2 Ascertain the PIN code 24
2.3 Tools menu 24
2.4 Main menu overview Husqvarna Automower® 310 / 315 25
2.5 Main menu overview GARDENA R100Li, R100LiC,R130Li,
R130LiC and R160Li 26
2.6 Tools menu overview 27
2.7 Tools menu, functions 28
3 Installation 35
3.1 Charging station 35
3.2 Boundary loop 36
3.3 Guide wire 38
3.4 Testing the installation 39
3.5 Calibrate guide 40
3.6 One robotic lawnmower for several working areas 41
3.7 Even mowing results in complex
working areas 41
3.8 Weather timer / Sensor Control 42
3.9 Safe operation on slopes 42
3.10 New loop signal 43
4 Autocheck Experience, Service program 44
4.1 Installation and login 44
4.2 Connection to the robotic lawnmower 45
4.3 Use 47
5 Repair instructions 54
5.1 Design and function 55
5.2 Disassembling and assembling the robotic lawnmower 59
5.3 Disassembling the charging station 63
5.4 Assembling the charging station 63
5.5 Replacing the charging strips 64
5.6 Replacing the battery on Husqvarna Automower® 310/315 64
5.7 Replacing the battery on GARDENA R100Li, R100LiC,
R130Li, R130LiC and R160Li 64
5.8 Replacing the main circuit board 65
5.9 Replacing the GARDENA Smartsystem board 66
5.10 Replacing the HMI circuit board 67
5.11 Replacing the keypad 68
5.12 Replacing the main switch 69
5.13 Cleaning or replacing the ventilation lter 69
5.14 Replacing the sensors 70
5.15 Replacing the blade motor 72
5.16 Replacing the wheel motor 73
5.17 Replacing the rear collision columns 73
5.18 Replacing the front collision column / lift sensor 74
5.19 Changing and regreasing lower front wheel bearing 75
5.20 Replacing the main circuit board, charging station 76
5.21 Replacing the contact strips, charging station 76
5.22 Assembling the sealing strip 77
5.23 Fitting Screws 78
5.24 Mounting thread plugs 78
5.25 Screw fasteners 79
6 Troubleshooting 80
6.1 Messages 81
6.2 Symptoms 87
6.3 Loop signal 90
6.4 Troubleshooting the loop signal 90
6.5 Finding a break in the boundary loop 92
6.6 Battery test 94
7 Maintenance and service 96
7.1 Cleaning 96
7.2 Winter storage 96
7.3 Service schedule 98
TABLE OF CONTENTS
TH_1158203_310_315_GARDENA_US.indd 3 2016-05-11 10:15:47
To Next Page
Loading...
Need help?
General
