English - 49
4.3.2 Manual test
Every component in the robotic lawnmower can
be tested in the manual test. The function consists
of four parts:
• Power/Motors
• User interface
• Sensors
• Loop
When using Manual test unlike Auto test, you have
to start and stop the components you wish to test.
When you have started a test, for example, of the
wheel motors, these will run until you click on Stop.
This provides greater control over the test. Manual
test is therefore appropriate to use when you want
to test a specic component and allow it to work
for a long period. Values are shown on screen
throughout the entire test.
4.3.3 Operating history
Operating history shows how well a robotic
lawnmower has been functioning. The function
is divided into two parts:
Operating data
Operating data displays information about the
mower’s
function divided into Key data, Search times
and Battery capacity. Trip is also displayed under
Operating data. Essentially the same information is
saved here
as under Key data, but with the difference
that the trip counter can be reset (just as the number
of kilometres can be reset in a car). This function is
ideal to use when you wish to see how the mower has
been functioning during a specic period.
To reset: Click on the Reset button.
Fault memory
This function displays the mower’s fault memory
divided in two lists. The left-hand list displays the
last 50 faults to occur. The right-hand list shows
how many times each fault message has occurred.
It is possible to sort both lists by clicking on the
headings for each list.
4.3.4 Programming
Programming entails updating the MSW, SSW
and HMI programs in the robotic lawnmower.
Ensure that Autocheck EXP is always updated
before programming commences.
Different main circuit boards in the mower and
additional equipment determine which software
4. AUTOCHECK EXPERIENCE, SERVICE PROGRAM
TH_1158203_310_315_GARDENA_US.indd 49 2016-05-11 10:16:13
To Next Page
Loading...
Need help?
General
