Hypertherm Powermax 85 Service Manual

powermax 65/85 Service Manual 8-1
Section 8
WIRING DIAGRAMS
In this section:
Cutting timing diagram page 1 of 2....................................................................................................................................................8-3
Cutting timing diagram page 2 of 2....................................................................................................................................................8-4
Electrical schematic diagram (CSA) ..................................................................................................................................................8-5
Electrical schematic diagram (CE) .....................................................................................................................................................8-6

Hypertherm Powermax 85 Specifications

General

Gas Supply	Clean, dry, oil-free air or nitrogen
Cooling Method	Fan-cooled
Input Voltage	200-600V, 3-phase
Current Output	25-85 A
Duty Cycle	60% @ 85 A
Recommended Gas Inlet Flow Rate/Pressure	6.7 scfm @ 85 psi
Cutting Capacity (Recommended)	1" (25 mm)
Gas Type	Air/Nitrogen