HySecurity UL 325 - Approved External Entrapment Sensors; NC Contact Sensors for HySecurity Gate Operators

Table 3: External Entrapment Protection Sensors Approved for Use with HySecurity
Gate Operators
The site designer or installer must determine which external entrapment protection sensors will be installed
with the gate operator to create a UL 325 compliant installation site.
NOTE: Table 3 provides the list of sensors that are approved for use with HySecurity gate operators using the monitoring
capabilities found in software versions h4.50 or h5.50 (or higher).
CAUTION
Temperatures and environmental conditions affect proper operation of external entrapment protection sensors.
Always check the manufacturer's specications shipped with the sensors.
External Entrapment Protection Sensors: Normally Closed Contact, Compatible with
HySecurity Gate Operators
P/N 2016 Monitored Sensors Sensor Type Output Manufacturer
UL 325
Recognized
MX3981
MX4161
Wired Gate Edge Sensor
MGR20-2U-05-T2, Round
Wraparound edge
(5 ft for 2" round post)
10K Resistor
Miller Edge Type B2
2 CH Gate Edge Module
(GEM-204)
Edge Interface Module Normally Closed
MX3982
MX4161
Wired Gate Edge Sensor
MGS20-2U-05-T2, Square
Wraparound edge
(5 ft for 2" square post)
10K Resistor
Miller Edge Type B2
2 CH Gate Edge Module
(GEM-204)
Edge Interface Module Normally Closed
MX4037
MX4161
KIT: Wired Gate Edge Sensor
MGO20-2E-05-T2, Square
and Channel mount
Edge (3-sided activation
Slide In Style)
(5 ft, 1½" width)
10K Resistor
Miller Edge Type B2
2 CH Gate Edge Module
(GEM-204)
Edge Interface Module Normally Closed
MX3985
Reecti-Guard (RG-R) Photo eye, reective Normally Closed
Miller Edge Type B1
MX4015
KIT: MGL-K20
(includes MX3986 and MX4013)
Wireless Gate Link Normally Closed
Miller Edge Yes
MX3986
MX4013
Wireless Gate Link
MGL-TX20
Transmitter (battery-
operated, radio control)
N/A
Miller Edge Yes
Wireless Gate Link
MGL-RX20
Receiver (24VDC, radio
control)
Normally Closed
MX3987
The Solution, MIM-62 Multi-Input Module Normally Closed
Miller Edge Yes
MX3990
IRB-MON (Dist.~ 65 ft) Thru-beam photo eye Normally Closed
EMX Industries Type B1
MX000846
KIT: IRB-325 (Dist.~ 50 ft) Thru-beam photo eye Normally Closed
EMX Industries Type B1
MX000999
KIT: E3K-R10K4-NR (Dist. ~ 40 ft) Photo eye, reective Normally Closed
Omron Type B1
NOTE: Bold type indicate sensors or accessories that must be installed together for external entrapment protection to be properly
monitored.
6 D0726 Rev. J UL 325 - 2016 HySecurity Monitored Sensors © 2016 www.hysecurity.com