Drive Belt Removal
l.
Position System Unit power switch to Off, unplug System Unit
power cord and disconnect all cables from rear
of
System Unit.
2.
Set the Display, Keyboard, and Printer away from System
/-....,
Unit working area.
3.
Remove System Unit cover (see page 3-98).
4.
Remove Diskette Drive (See page 3-7).
5.
Carefully place Diskette Drive on work surface with drive belt
and pulleys facing up.
6.
Lift belt off large pulley; then lift belt off small pulley.
(Bottom View)
Drive Belt Replacement
1.
Place drive belt around small pulley (dark shiny side facing
pulleys), then place belt aroupd large pulley.
/-....,
2.
Replace Diskette Drive (See page 3-9).
3.
Replace System Unit cover (See page 3-98).
4.
Reconnect cables to System Unit.
3-15
To Next Page
Loading...
