IBM 5150 - Diskette DriveA Replacement

Diskette Drive "A" Replacement
1. Slide Diskette Drive" A" in until front panel is approximately 2
inches from frame and connect power cable to Diskette Drive
Logic Circuit Board.
F ace Plate
-.......,~
Front Panel
r""\
2.
3.
4.
Slide Diskette Drive" A" in until faceplate is even with front
panel.
Route signal cable between Diskette Drive and power supply.
Connect end
of signal cable to Diskette Drive.
Install the two side mounting screws.
(Side View)
Mounting Screws !
3-9