IBM 5150 - Intermediate Gear Replacement

Intermediate Gear Replacement
l.
Slide intermediate gear
monto shaft.
2.
Replace retaining-clip
iii.
r"'... 3.
Place forms feed motor
II onto mounts.
4. Install two screws
mbut do not tighten.
5.
Position motor to mesh gears with minimum backlash
II
and no binding.
6.
Tighten two screws.
7.
Replace top cover (See page 3-90).
8.
Replace access cover.
9.
Replace forms rack.
I _ -1----11
C_
3-65