Drive Motor Replacement
1.
Place drive motor in position, aligning threaded holes in motor
with holes in frame (motor wiring harness should face rear
of
machine).
I~
2.
Replace mounting screws and shouldered washers.
3.
Replace drive belt (See page 3-15).
4. Connect drive motor cable to servo board at Connector 21.
5.
Replace Diskette Drive Logic Printed Circuit Board
(See page 3-26).
6.
Replace System Unit cover (See page 3-98).
7.
Reconnect cables
to
System Unit.
o
~_-
Drive
Motor
1-....
Connector
21
Shouldered
Mounting
Screws
3-17
To Next Page
Loading...
