Diskette Drive Logic Printed Circuit Board
Replacement
1.
Connect Diskette Drive power connector at left rear
of
Diskette
Drive Logic Printed Circuit Board.
2. Align notches
1m
on sides
of
Logic Printed Circuit Board with
~
guide brackets
m;
and lower Logic Printed Circuit Board ./
onto brackets.
3. Slide Logic Printed Circuit Board toward front
of
machine until
holes in Logic Printed Circuit Board line up with threaded holes
for retaining screws
II.
1-+--+---
Diskette Power
Connector
Top
View
3-26
To Next Page
Loading...
