IBM 6400 Maintenance Information Manual

Message List
101
ERROR: FLASH DID
NOT PROGRAM
The printer
encountered an error
trying to program
flash memory.
1. Download the program again.
2. If the message occurs again, replace the
flash memory with pre-written flash. (See
Table 8 and Table 9 on page 219 and
Figure 35 on page 220.)
ERROR OCCURRED
FLUSHING QUEUES*
An interim message
that displays while the
printer discards host
data it cannot use
because a fault
condition exists.
While this message
displays, the asterisk
(*) rotates.
Wait. When the asterisk (*) stops rotating, a
different fault message will appear:
troubleshoot the final message.
ERROR: PROGRAM
NOT VALID
The printer does not
see a program in
flash memory.
There is no program in printer memory.
Download the emulation.
ERROR: SECURITY
PAL NOT DETECTED
The security PAL is
missing or has failed.
Power off the printer.
Remove the paper
guide assembly or
pedestal top cover.
1. Check the security PAL at location U54
on the CMX controller board. If the PAL is
absent, install the correct PAL. If a
security PAL is present, replace it.
2. Power on the printer. If the message
appears, replace the CMX controller
board. Record the message and return it
with the defective board.
ERROR: SHORT AT
ADDRESS XXXX
Hardware failure in
DRAM or CMX
controller circuitry.
1. Download the program again.
2. If the message appears again, replace
the DRAM. If message occurs with new
memory, replace the CMX controller
board. Record the message and return it
with defective CMX board.
ETHERNET ADAPTER
BEING INITIALIZED
Status message that
indicates that the
internal Network
Interface Card is
processing the boot
procedure. (May
occur with older
versions of
microcode.)
No action required.
Table 4. Message List
Operator Panel
Message
Explanation Corrective Action

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English