EasyManuals Logo

IBM 6500 User Manual

IBM 6500
334 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
Timeout
This is the value used by the printer to time out from the current port and check
the other ports for data to print. When the printer has not received data from the
host after the specified period of time, it needs to Timeout to service the other
ports. The available selections are:
v 15 Seconds (the default).
v 10 to 180 Seconds.
Report Status
v Disable (the default). A fault on the printer is reported only if it occurs on the
active port.
v Enable. The faults are reported even if the fault is not on the current active port.
Maximum Printable Width
Sets the maximum width of the printer when using a CT host interface.
v 13.2 Inches (the default)
v 13.6 Inches
Note:
The 5250 interface menu and 3270 interface menu option for maximum
printable width use the same internal variable. Setting this option in either
menu will make it the current setting for the printer, independent of the
interface used.
Although the LP+ emulation maintains width in characters, the maximum
printable width in characters is controlled by the same internal variable that
is set by the 5250 interface menu and 3270 interface menu option for
maximum printable width option.
Chapter 4. The Configuration Menus 103

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM 6500 and is the answer not in the manual?

IBM 6500 Specifications

General IconGeneral
BrandIBM
Model6500
CategoryPrinter
LanguageEnglish

Related product manuals