Signal Strength
This menu displays the strength of the wireless signal.
Note:
This is a display value only and cannot be changed.
SSID Name
A 1 - 32 character, case sensitive string that identifies the group the printer talks to.
Note:
The SSID name may be edited in three parts (1 - 15), (16 - 30), and (31 - 31).
For each part of the SSID name, press the MICRO UP or MICRO DOWN keys to
cycle through the values available for that character at the cursor location. Press
the SCROLL UP key to move to the next character to be modified. Press the
SCROLL DOWN key to go back to a character you have already modified.
Continue until you have entered the name you want to give to this SSID name,
then press ENTER to save. The name you entered will now represent this SSID
name on the printer’s front panel. To exit this menu without saving, press any key
other than the ENTER key. The SSID name will revert to the last saved value.
Reset SSID Name
Allows you to reset the SSID name.
Operation Mode
Allows you to select the way the Wireless option communicates:
v Infrastructure (default). The Wireless option must go through a server.
v Ad Hoc. Standard, peer-to-peer communication (without a server). The two
peers can be from different manufacturers.
v Pseudo IBSS. Proprietary, peer-to-peer communication (without a server). The
two peers must be specific to one manufacturer.
Minimum Transfer Rate
Allows you to set the minimum speed at which the Wireless Option will accept a
connection (in million bits per second). The options are:
v Auto-negotiate (default)
v 1Mb/sec.
v 2Mb/sec.
v 5.5Mb/sec
v 11Mb/sec
Channel
Allows you to select the RF channel. The options are Default (the factory default)
and 1-15.
120 Infoprint 6500 User’s Manual
To Next Page
Loading...
Need help?
General