Print Quality
Note: When using bold or emphasized printing, the printer prints two dots instead
of one to produce the desired effect. This does not affect characters per inch.
This parameter specifies the density (quality) of printing:
v DP Quality (the default)
v Near Letter Quality
v OCR A
v OCR B
v Draft
v NLQ Sans Serif
Note:
Receipt of a data stream control sequence that changes the print quality
overrides the print quality specified via the operator panel.
Specifying a print quality of OCR A or OCR B will change the print language to
OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A/OCR B
are the only available values for this parameter. If a different print quality value is
desired, the print language must be changed first.
Print Character Table
This parameter prints out a table of the current interface character set.
Print Attributes
The PRINT ATTRIBUTES parameter is used to determine character and page
formatting.
Proportional Spacing: Uses proportional spacing for text data when enabled.
v Disable (the default)
v Enable. Uses proportional spacing for text data.
Note:
Proportional spacing is only supported in 10 CPI. Therefore, you must select
10 CPI, or proportional spacing will be ignored.
Italic Print: Prints text in italics, when enabled. Both a forward and backwards
slanting italic are available.
Disable (the default)
Forward Slant. Uses italic print that slants forward.
Backward Slant. Uses italic print that slants backward.
Chapter 4. The Configuration Menus 197
To Next Page
Loading...
Need help?
General