6500-LU0-DSC-Local Non-SNA 3174 Control Unit
LU0-DSC mode is utilized when no host printing controls are required to
accomplish the print function desired and the control unit is attached by a
VTAM-Controlled NON-SNA Control Unit. An existing local 3174
NON-SNA-connected control unit is assumed. The steps required to install an
LU0-DSC printer for host definitions are as follows:
1. Define to VTAM by adding logmode entry to VTAM Logmode Table
2. Define to JES2 (Not required but recommended. See details below)
3. Define to CICS or another Application Program such as VPS or JES328X
products.
4. Select the options on the printer that are appropriate for the environment.
Step 1 - VTAM Definition
The following should be added to the Local Major Node VTAM definition. The
printer will be attached as an LU1-IPDS capable printer.
LOC3174 VBUILD TYPE=LOCAL
LOCPU74 PU CUADDR=nnn...
LOC6500 LU
LOCADDR=n,MODETAB=MYMODETB,DLOGMODE=printer,ISTATUS=ACTIVE
The following entry should be placed in the VTAM MODE TABLE specified above
or another of your choice.
6500DSCL MODEENT LOGMODE=6500DSCL,
FMPROF=X'02',TSPROF=X'02',PRIPROT=X'60',
SECPROT=X'40',COMPROT=X'0000',RUSIZES=X'C7C7',
PSERVIC=X'000000000000185018507F00'
PSNDPAC=X'80',SRCVPAC=X'00',SSNDPAC=X'00'
Step 2 - JES2 Definition (SYS1.PARMLIB)
RMT1 LUTYPE0,BUFSIZE=3840,LINE=1,NUMRD=0,NUMPR=1,NOCOMP,NOCMPCT,
SETUPHDR,CONSOLE
R1.PR1 CLASS=A,NOSEP,PRWIDTH=132,NOFCBLOD,WS=(W,R,Q,PMD,LIM,F,T/C,P),
CKTPAGE=30
DESTID NAME=LOC6500,DEST=R1
282 Infoprint 6500 User’s Manual
To Next Page
Loading...
Need help?
General