Step 2 - VTAM Definition
* The following entry should be placed in the VTAM MODE TABLE specified
above or another of your choice.
6500DSER MODEENT LOGMODE=6500DSER
FMPROF=X'03',TSPROF=X'03',PRIPROT=X'B1',
SECPROT=X'90',COMPROT=X'3080',RUSIZES=X'87C6',
PSERVIC=X'038000000000185018507F00'.
PSNDPAC=X'01',SRCVPAC=X'01'
Step 3 - JES2 Definition
This definition is not required if you are using VPS and using U1 - U9999 as the
printer ID.
RMT1 LUTYPE3,BUFSIZE=3840,LINE=1,NUMRD=0,NUMPR=1,NOCOMP,NOCMPC ,
SETUPHDR,CONSOLE (SETUPHDR=PDIR JES2 V3)
R1.PR1 CLASS=A,NOSEP,PRWIDTH=132,NOFCBLOD,WS=(W,R,Q,PMD,LIM,F,T/C,P),
CKPTPAGE=30
DESTID NAME=P6500,DEST=R1
Step 4 - Define to CICS or another application program
Refer to the vendor documentation for defining a DSE printer to the program for
its use. Host system commands to change printer settings are not supported in
DSE mode.
Step 5 - Printer Settings
It is recommended that the following printer settings be changed from factory
default settings:
v Printer Control => Interface Selection => Coax
v Coax Interface => Format Control => Enable
v Coax Interface => Early Print Complete => Enable
Since
the host controls are not supported, the printer settings for CPI, LPI, and
others should be set at the printer.
Appendix D. Attaching Host Systems to a Coax/Twinax Printer 281
To Next Page
Loading...
Need help?
General