Step 3 - Define to CICS or another application program
Host commands for changing printer settings are not supported in this mode.
Refer to the vendor documentation for defining an DSC printer to the program for
its use.
Step 4 - Printer Settings
It is recommended that the following printer settings be changed from factory
default setting:
v Printer Control => Interface Selection => Coax
v Coax Interface => Format Control => Enable
v Coax Interface => Early Print Complete => Enable
In
LU0 mode the printer settings control the orientation, CPI, LPI and all other
aspects of the printed output. Therefore, you must set the printer settings to match
the characteristics of the job you are printing. Host controls are not supported in
this mode.
Attaching Printer to VM Host System
Below are sample execs you can read in order to help you to understand how to
attach this printer to a VM host system:
SNA Attachment
Sample exec file for attaching with SNA protocols:
/* Signal JUST_VM */
’CP SMSG VTAMOPX F NET,DEFAULTS,ID=LS6C004,DLOGMOD=LU1PRT’
/* ’CP SMSG VTAMOPX F NET,DEFAULTS,ID=LS6C004,DLOGMOD=LU3PRT’ */
pull upper pause
’SMSG RSCSCOAX STOP SNA6C004’
’SMSG RSCSCOAX DELET SNA6C004’
’SMSG RSCSCOAX DEFINE SNA6C004 LUNAME LS6C004 TYPE SNA3270P’
/* ’SMSG RSCSCOAX DEFINE SNA6C004 PARM VFC=YES SEP=YES TR=ASISCC’ */
’SMSG RSCSCOAX DEFINE SNA6C004 PARM VFC=YES SEP=NO TR=ASISCC’
/* ’SMSG RSCSCOAX DEFINE SNA6C004 PARM VFC=YES SEP=NO’ */
’SMSG RSCSCOAX START SNA6C004 CLASS * QUEUE FIFO FORM *’
JUST_VM:
’CP SPOOL PRINT TO RSCSCOAX’
’CP TAG DEV PRT TO SNA6C004 SYSTEM 1’
’CP TA DE PRT SNA6C004 SYSTEM 1’
Appendix D. Attaching Host Systems to a Coax/Twinax Printer 283
To Next Page
Loading...
Need help?
General